Today in electronics i got to put my LED lights in my picture and triangular plastic.
I had to cut a few edges off the LED to make it fit on to the copper tape then i had to do the other side.
I had to get my resisters and i had to cut the small end of my LED to make it fit on to the resistor
the tricky part about this though was trying to solder the resister on to the LED to make it fit and then if
the end of the resistor was going over the copper tape then i would have to cut it.
8/wednesday/2017
today i am finishing off my light but befor i had to do this
KEY ATTRIBUTES
| ||
Portable
|
Durable
|
Parallel Circuit
|
Why. so you can move it around and hang it at different places
|
Why. so it can stay strong
|
Why. so if 1 light goes out the rest will stay lit
|
How: it is light a easy to carry around.
|
how . glue it strong together and make the glue stick to every edge
|
O every How. Because all the resistors will still be connected and if 1 goes out the rest will stay lit up.
|
